19-5
Cisco ME 3400 EthernetAccess Switch SoftwareConfiguration Guide
78-17058-01
Chapter19 Configuring Dynamic A RP In spection Configuring Dynamic ARP Inspection
You use the ip arp inspection log-buffer global configuration command to configure the number of
entries in the buffer and the number of entries needed in the specified interval to generate system
messages. You specify the type of packets that are logged by using the ip arp inspection vlan logging
global configuration command. For configuration information, see the “Configuring t he Log Buffer”
section on page 19-13.
Configuring Dynamic ARP Inspection
These sections contain this configuration information:
Default Dynamic ARP Inspection Configuration, page 19-5
Dynamic ARP Inspection Configuration Guidelines, page 19-6
Configuring Dynamic ARP Inspection in DHCP Environments, page 19-7 (required in DHC P
environments)
Configuring ARP ACLs for Non-DHCP Environments, page 19-8 (required in non-DHCP
environments)
Limiting the Rate of Incoming ARP Packets, page 19-10 (optional)
Performing Validation Checks, page 19-12 (optional)
Configuring the Log Buffer, page 19-13 (optional)

Default Dynamic ARP Inspection Configuration

Table19-1 shows the default dynamic ARP inspection configuration.
Table19-1 Default Dynamic ARP Inspection Configuration
Feature Default Setting
Dynamic ARP inspection Disabled on all VLANs.
Interface trust state All interfaces are untrusted.
Rate limit of incoming ARP packets The rate is 15 pps on untrusted interfaces, assuming that
the network is a switched network with a host
connecting to as many as 15 new hosts per second.
The rate is unlimited on all trusted interfaces.
The burst interval is 1 second.
ARP ACLs for non-DHCP environments No ARP ACLs are defined.
Validation checks No checks are performed.
Log buffer When dynamic ARP inspection is enabled, all denied or
dropped ARP packets are logged.
The number of entries in the log is 32.
The number of system messages is limited to 5 per
second.
The logging-rate interval is 1 second.
Per-VLAN logging All denied or dropped ARP packets a re log ged.