5-103
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfcasonhooktime
cnfcasonhooktimeTo configure a minimum presence time, on an endpoint, for a CAS on-hook pattern to be re co gnized as
an on-hook signal, use the cnfcasonhooktime command in the VoIP switching/trunking and switched
AAL2 PVC operating modes.
cnfcasonhooktime endpt-num onhooktime
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines To use this command, you must ensure that the endpoint indicated by the endpt-num argume nt value has
been previously added, and that the associated DS0 is configured for CAS.
Note To use this command, you must choose the MIB as the source in the cnfcasparamsource co mmand.
Examples The following example shows that endpoint 100 is configured wi th an on-h ook t ime of 500 ms :
cnfcasonhooktime 100 500
endpt-num The endpoint number which is to be configured with a guard time, identified by the
onhooktime argument value. It can be a value from one of the following rang es:
•For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
•For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
•For template number 4:
–
For VISM-PR, from 1 to 144
onhooktime The on-hook time (defined in milliseconds); in the range from 10 to 1000.
(Default = 300)