4-19
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter4 Configuring VISM Features
Configuring VISM Features
–
For template number 2:
For VISM T1, in the range from 1 to 192
For VISM E1, in the range from 1 to 248
–
For template number 3:
For VISM, in the range from 1 to 120
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
–
For template number 4:
For VISM-PR, in the range from 1 to 144
•start-line-num (DS1 line): In the range from 1 to 8
•start-ds0-num (DS0 channel):
–
For T1 lines, from 1 to 24
–
For non-CAS E1 lines, from 1 to 31
–
For CAS E1 lines, from 1 to 15 and 17 to 31
•endpt-quantity:
–
For template number 1:
For VISM, in the range from 1 to 145
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
–
For template number 2:
For VISM T1, in the range from 1 to 192
For VISM E1, in the range from 1 to 248
–
For template number 3:
For VISM, in the range from 1 to 120
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
–
For template number 4:
For VISM-PR, in the range from 1 to 144
Step 3 Type the addendptloop command, an endpt-num argument value, and press Enter to place a specific
endpoint—and so a specific DS1/DS0—into the loopback state in the TDM direction. Specify the
endpt-num argument value from the following ranges:
•For template number 1:
–
For VISM, in the range from 1 to 145
–
For VISM-PR T1, in the range from 1 to 192
–
For VISM-PR E1, in the range from 1 to 248
•For template number 2:
–
For VISM T1, in the range from 1 to 192
–
For VISM E1, in the range from 1 to 248