ENGLISH EN
Procedures For Transpoting (cont.)
10.Fasten the machine to the vehicle. Clarke recommends a strap over the top of the machine and a strap to keep the machine from rolling forward or backwards. If this is not done, there is a possibility of the machine toppling over. Four tie down points (2 along each side of frame) are provided on machine for securing machine.
How to Remove the Machine From a Van or
Truck
1. Make sure there are no obstructions in the area.
Figure #2
2.Make sure the unloading ramp is at least eight
(8) feet (2.5m) long and a minimum of 32"
(0.8m) wide, and strong enough to support the machine.
3.Make sure the ramp is clean and dry.
4.Put the ramp in position.
5.Unfasten the machine.
WARNING: The machine is heavy. Make sure you use two able persons to assist in moving the machine down the ramp.
6.Turn the key switch "ON".
7.Set the traverse center knob to the slowest forward speed setting. Carefully and slowly, drive the machine to the top of the ramp and start down.
8.While pushing in the right or left forward/reverse switch the machine will go forward. See figure 2.
9.As the machine begins to travel down the ramp, push in the forward/reverse switch to maintain a slow downward speed.
10.Replace squeegee assembly after machine is unloaded and ready to use.
Clarke® Operator's Manual (EN) - BOOST 28 | - 7 - |