2.0. Mounting TV with a flat back

Note: The plastic cover (shown in dotted lines) is only provided on model number TP150B; but NOT on model number TC105B. The pin [04] is shipped pre-inserted into the “STORE” opening on the bracket [03].

Note: Most flat screen TVs are provided with Digital Optical Audio Output on the back of the TV. If your TV has one, locate the Digital Optical Audio Output – as this will be used later.

Position the motorized bracket [02] and the non-motorized bracket [03] on the back of the TV so that the bottom of the two brackets [02] and [03] are at least 1.5 in. (38.1 mm) from the bottom of the TV.

Use the screws provided with the TV to attach the motorized bracket [02] and the non-motorized bracket [03] to the back of the TV. If screws are not provided with the TV, then select the correct screw [15, 16, 17, 18] by hand threading them into the threaded insert on the back of the TV. Stop immediately if you encounter any resistance.

If the distance between the two threaded inserts on the back of the TV is greater than 31.5 inches (800mm), then the two brackets [02] and [03] may not fit the wall brackets [01].

10