KNOW YOUR UNIT

Gear Housing

Drive Shaft

Assembly

Hanger

Indexing Ring

Adjustment Bolt

Angle

Adjustment

Handle

Blade

WARNING: DO NOT USE an extension boom with this product. It is not designed to be used with an extension and using one may cause serious injury.

ASSEMBLY INSTRUCTIONS

INSTALLING / REMOVING THE ATTACHMENT

WARNING: Read and understand operator’s manual for unit to be used with this attachment prior to operation.

WARNING: To avoid serious personal injury and damage to the unit, shut unit off before removing or installing attachments.

Installing the attachment:

NOTE: To make installing or removing the attachment easier, place the unit on the ground or on a work bench.

1.Remove the hanger from the top of the shaft housing.

2.Turn knob counterclockwise to loosen (Fig. 1).

Craftsman Convertible™

Release Button

Coupler

 

Primary Hole

 

Upper Shaft

Lower Shaft

Housing

Housing

 

Knob

 

Fig. 2

Tighten

Loosen

Knob

Craftsman Convertible™

Release Button

Guide Recess

Coupler

Knob

Fig. 3

Fig. 1

3.While firmly holding the attachment, push it straight into the coupler until the release button snaps firmly into the primary hole (Fig. 2).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 3).

CAUTION: Lock the release button in the primary hole (Fig. 2) and securely tighten the knob before operating this unit.

4.Turn the knob clockwise to tighten (Fig. 1).

CAUTION: The attachments with the coupler system are to be used in the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit.

5