KNOW YOUR UNIT

 

 

Muffler

Spark

Oil Fill Plug

 

 

Plug

 

 

 

Starter Rope

 

 

 

 

Grip

 

 

 

 

Shaft Grip

 

 

 

 

On/Off Stop

 

 

 

D-Handle

Control

 

 

 

 

 

 

Fuel Cap

 

Twist & Edge and

 

 

Choke Lever

 

Craftsman

 

 

 

 

 

 

 

Convertible™ Coupler

 

 

 

 

 

Throttle

 

 

Line

 

Control

 

 

 

 

 

 

Cutting

 

 

 

 

Blade

Shaft

 

 

 

 

Housing

Air Filter Cover

 

Primer Bulb

 

 

 

Cutting Attachment

Shield

HassleFree™

ASSEMBLY INSTRUCTIONS

INSTALLING AND ADJUSTING THE D-HANDLE

1.Remove the screws and bottom clamp piece that were installed on the D-handle for shipping.

2.Place D-handle the over the shaft housing and onto the bottom clamp (Fig. 1). Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip.

3.Start screws with a large Flat-head or T-25 Torx screwdriver. Do not tighten until you make the handle adjustment.

4.If the D-handle was pre-installed, loosen the screws on the handle just enough to move it.

5.While holding the unit in the operating position (Fig. 13), position the D-handle to the location that provides you the best grip.

On/Off Stop Control

(4) Screws

Shaft

6.Tighten the clamp screws evenly, until the D-handle is secure.

INSTALL LINE TRIMMER ATTACHMENT

NOTE: To make installation easier, place the unit on the ground or on a workbench.

1.Turn knob counterclockwise to

loosen coupler (Fig. 15, p. 8).

2. While firmly holding attachment, push it straight into the coupler until the release button snaps into the primary hole (Fig. 16, p. 9).

NOTE: Aligning the release button with the guide recess (Fig. 16, p. 9) will help installation.

Housing

Shaft Grip

3. Turn the knob clockwise to tighten.

LINE TRIMMER APPLICATIONS

Fig. 2

Minimum 6 Inches

(15.24 cm)

D-Handle

Bottom Clamp

Fig. 1

Cutting grass and light weeds; edging; and decorative trimming around trees, fences, etc.

5