Tools Required for Assembly
Adjustable wrench
Allen wrench
Remove Pressure Washer from Carton
•Open carton from the top. Locate and remove from box the handle, gun, wand, videotape, and oil.
•Cut carton along dotted lines.
•Remove all carton inserts.
•Roll unit through opening in carton.
NOTE: The hose is located at the bottom of the box.
Preparing the Pressure Washer for First Use
Note: Included with your pressure washer is a video cassette tape on how to prepare your unit for operation. It is recommended you view this tape before performing the next steps.
1. Insert handle onto frame.
•Insert knobs into the threaded slot in front of the frame handle and tighten by turning in a
•Slide bolts into the slot in the side of the frame handle and tighten the nuts by turning in a
Insert bolt and tighten
lock nut.
Tighten knob in
clockwise direction
2. Using an adjustable wrench, remove nut from bolt that attaches board to frame. Remove wood plank from the frame of the unit. Discard bolt and board.
3.Mount the rubber isolator to the frame. To
mount isolator place threaded end of bolt through the washer.
•Next with washer on bolt place threaded end of bolt through the larger hole in bottom of the rubber isolator.
•Place threaded portion of bolt through the same hole location the wood plank was mounted to on the pressure washer.
•Next place the tee nut over the threaded portion of the bolt and use the Allen wrench provided to tighten isolator to the frame.
TEE NUT
PRESSUREISOLATOR
WASHER
FRAME
WASHER
BOLT
4.Connect wand extension to gun. To tighten, turn knob in clockwise direction. Hand tighten.
5.Remove tie wrap off of high pressure hose. Unwind high pressure hose and attach the threaded end to the gun. Tighten with adjustable wrench.
6.Connect high pressure hose to outlet on pressure washer and hand tighten firmly. Connect chemical pickup hose to hose barb on pump.
|
|
|
| HIGH |
|
|
|
| PRESSURE |
|
|
|
| |
CHEMICAL |
|
|
| HOSE |
| ||||
HOSE |
|
|
|
|
NOTE: Always keep hose away from engine muffler.
6
