LANDON TWO DOOR CUPBOARD

OPTIONAL SAFETY MOUNTING INSTRUCTIONS

For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe mounting, it is essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs whenever possible.

A)Determine the final location of unit. Mark position on the wall, approximately 2" below the top of unit as shown.

B)Drill a pilot hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is slightly smaller in diameter than the plastic anchor. Gently tap the plastic anchor until the flange of the plastic anchor is flush with the wall.

C)Insert large screw through end of wall strap and through the plastic anchor in the wall as shown.

D)Insert small screw through end wall strap and into the top back of unit as shown.

Mounting assembly is now complete.

NOTE: If you are unsure about your wall type or what mounting method you should use, consult a qualified professional or your local hardware store.

SIDE VIEW DETAIL WALL
wall strap
(NOTE: Insert screws
3/4"-1" from the
edge of the strap) small screw
large screw
plastic anchor

HINGE ADJUSTMENT

If the doors do not appear square or aligned, loosen or tighten the appropriate screws on each case hinge as illustrated.

1) Side to side adjustment:2) Depth adjustment:
Loosen screw A, adjust gap
Loosen screw A, push hinge arm
with screw B and re-tighten
forwards or backwards, re-tighten
screw A.

screw A.

3)Height adjustment: Loosen screw C, adjust door height and re- tighten screw C.

 

 

C

 

A

A

 

B

 

 

 

C

1

2

3

Made in China - r04

Customer Service 800.967.6696 Latest instructions available at www.crateandbarrel.com

Page 4 of 4