WINDHAM CORNER MEDIA STAND

 

wall

plastic

strap

A screwsmall

anchor

 

anti-tip

 

F bracket

C

 

wall

 

bracket

 

 

Dscrewlarge

10Safety Mounting Instructions

For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe mounting, it is essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs whenever possible.

A)Attach anti-tip bracket to top of media stand using 2 small screws as shown.

B)Determine the final location of media stand. Mark position on the wall, approximately 2" below the anti-tip bracket mounted to the back of the media stand.

C)Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is slightly smaller in diameter than the anchor. Gently tap the plastic anchor until the flange of the anchor is flush with the wall.

D)Attach the wall bracket to the wall by inserting 1 large screw through the wall bracket and into the wall anchor in the wall.

E)Place the unit so the anti-tip bracket on the back edge is allowed with the wall bracketl.

F)Lace one end of the wall strap through both brackets, and into the other end of the strap.

G)Pull the strap tightly until secure.

Repeat steps A-G for remaining anti-tip and wall bracket.

NOTE:

If you are unsure about your wall type or what mounting method you should use, consult a qualified professional or your local hardware store.

Made in China - r05

Customer Service 800.967.6696 www.crateandbarrel.com

Page 5 of 5