Weight:
Shipping 5.0 lbs.
Net 4.3 lbs.
Dimensions:
Diameter 4.66"
Height 2.82"
Recommended Horn: AM100H
C.Unpacking.
After unpacking the Model AM100D, examine it for damage that may have occurred in transit.
If the equipment has been damaged, do not attempt to install or operate it. File a claim
immediately with the carrier stating the extent of the damage. Carefully check all envelopes,
shipping labels and tags before removing or destroying them.
D. Installation.
1. Position the supplied washer in the throat of the horn.
2. Screw the driver into the horn.
WARNING
This unit is heavy and should be mounted on a rigid surface capable of supporting the weight
of the speaker.
3. Install the horn/driver assembly in intended location, referring to the instructions provided
with the horn.
4. Route the speaker wiring to the horn/driver assembly.
WARNING
Do not connect wires when power is applied.
5. Connect the speaker wiring to the speaker wire leads.
CAUTION
When connecting multiple speakers, polarity MUST be maintained. Ensure that all red wires are
connected to the same audio output lead, and that all black wires are connected
to the same audio output lead.
E. Service.
CAUTION
Any maintenance must be performed by a trained electrician in accordance with
NEC guidelines and local codes.
Do not perform maintenance on this device while the system power is on.
Federal Signal will service your equipment or provide technical assistance with any problems
that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied by
a Return Material Authorization. This R.M.A can be obtained from the local Distributor or
Manufacturer’s Representative.
At this time a brief explanation of the service requested or the nature of the malfunction,
should be given.
Address all communications and shipments to:
FEDERAL SIGNAL CORPORATION
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
-2-