Adding a NAT/Route Int -> Ext policy
Adding Transparent mode policies
Add Transparent mode policies to control the network traffic that is allowed to pass through the firewall when you are running the it in Transparent mode.
•Go to Firewall > Policy .
•Select a policy list tab.
•Select New to add a new policy.
You can also select Insert Policy before on a policy in the list to add the new policy above a specific policy.
•Configure the policy:
Source
Destination
Schedule
Service
Select an address or address group that matches the source address of the packet. Before you can add this address to a policy, you must add it to the source interface. To add an address, see Addresses.
Select an address or address group that matches the destination address of the packet. Before you can add this address to a policy, you must add it to the source interface. To add an address, see Addresses.
A schedule that controls when this policy is available to be matched with connections. See Schedules.
A service that matches the service (port number) of the packet. You can select from a wide range of predefined services, or add custom services and service groups. See Services.
27 | |
|