The table below lists the parameters controlled by a radio profile and their default values.

Parameter

Default Value

Radio Behavior When Parameter Set to Default Value

 

 

Sends probe any requests (probe requests with a

active-scan

enable

null SSID name) to solicit probe responses from

 

 

other access points.

 

 

 

auto-tune

enable

Allows dynamic configuration of channel and power settings by

MMS.

 

 

 

 

 

beacon-interval

100

Waits 100ms between beacons.

 

 

 

countermeasures

Not configured

Does not issue countermeasures against any device.

 

 

 

dtim-interval

1

Sends the delivery traffic indication map (DTIM) after every

beacon.

 

 

 

 

 

 

 

Uses the short-retry-count for frames shorter than 2346 bytes

frag-threshold

2346

and uses the long-retry-count for frames that are 2346 bytes or

 

 

longer.

 

 

 

max-rx-lifetime

2000

Allows a received frame to stay in the buffer for up to 2000ms (2

seconds).

 

 

 

 

 

max-tx-lifetime

2000

Allows a frame that is scheduled for transmission to stay in the

buffer for up to 2000ms (2 seconds).

 

 

 

 

 

 

 

Advertises support for short 802.11b preambles, and generates

preamble-length

short

unicast frames with the preamble length specified by the client.

 

 

 

Note: This parameter applies only to 802.11b/g radios.

 

 

 

 

 

Classifies and marks traffic based on 802.1q and DSCP,

qos-mode

wmm

and optimizes forwarding prioritization of AP radios for Wi-Fi

 

 

Multimedia (WMM).

 

 

 

rfid-mode

disable

Radio does not funtion as a location reciever in an AreoScout

Visibility System.

 

 

 

 

 

rts-threshold

2346

Transmits frames longer than 2346 bytes by means of the

Request-to-Send/Clear-to-Send (RTS/CTS) method.

 

 

 

 

 

service-profile

No service profiles defined

You must configure a service profile. The service profile sets the

SSID name and other parameters.

 

 

 

 

 

wmm-powersave

disable

Requires clients to send a seperate PSpoll to retrieve each

unicast packet buffered by the AP.

 

 

 

 

 

D-Link DWS-1008 CLI Manual

347

Page 350
Image 350
D-Link dws-1008 manual Link DWS-1008 CLI Manual 347, Mms