DWS-1008#set port poe 3,5 disable

If you are enabling power on these ports, they must be connected only to approved PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

The following command enables PoE on ports 2 and 4:

DWS-1008#set port poe 2,4 enable

If you are enabling power on these ports, they must be connected only to approved PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

See Also:

set port type ap

set port type wired-auth

set port speed

Changes the speed of a port.

Syntax: set port speed port-list{10 100 auto}

port-list

10

100

auto

List of physical ports. MSS sets the port speed on all the specified ports.

Sets the port speed of a 10/100 Ethernet port to 10 Mbps and sets the operating mode to full-duplex.

Sets the port speed of a 10/100 Ethernet port to 100 Mbps and sets the operating mode to full-duplex.

Enables a port to detect the speed and operating mode of the traffic on the link and set itself accordingly.

Defaults: All ports are set to auto.

Access: Enabled.

Usage: D-Link recommends that you do not configure the mode of a switch port so that one side of the link is set to autonegotiation while the other side is set to full-duplex. Although MSS allows this configuration, it can result in slow throughput on the link. The slow throughput occurs because the side that is configured for autonegotiation falls back to half-duplex. A stream of large packets sent to a switch port in such a configuration can cause forwarding on the link to stop.

D-Link DWS-1008 CLI Manual

49

Page 52
Image 52
D-Link dws-1008 manual Set port speed, DWS-1008#set port poe 3,5 disable, DWS-1008#set port poe 2,4 enable, Auto