3
Radio and Television Interference
UNITED STATES: The equipment described in this manual generates and uses radio frequency energy. If it is
not installed and used in accordance with the instructions in this manual, it may cause interference with radio
and television reception.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
aresidential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with these instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient or relocate the receiving antenna;
2. Increase the separation between the equipment and the receiver;
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
If necessary, consult your dealer or an experienced radio/TV technician for help and/or additional suggestions.
You may find the following booklet helpful: How to Identify and Resolve Radio-TV Interference Problems,
booklet number 004-000-00345-4, prepared by the Federal Communications Commission. It is available from
the United States Government Printing Office, Washington D.C. 20402.
Note: Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s right to operate this equipment.
Peripherals used in conjunction with this equipment must be connected via shielded interface cables. Use of
unshielded interface cables may result in interference to radio and TV reception, and may void the user’s right to
operate this equipment.
Model Number: MP-4100
Trade Name: Datavideo
Responsible: Datavideo Corporation (USA)
Address: 12300-U East Washington Blvd., Whittier CA 90606, USA
Telephone: (562) 696-2324
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.