Denon 685, AVR-1705 After starting playback, [1], BASS, NOTE:, TREBLE, Example: Stereo, Input mode display, Input signal display, Adjusting the sound quality (tone)

ENGLISH

3	Select the play mode.
	Press the SURROUND MODE button, then turn the SELECT

knob.

Example: Stereo

(Main unit)(Remote control unit)

To select the surround mode while adjusting the surround parameters, tone defeat or tone control, press the surround mode button then operate the selector.

Input mode display

• In the AUTO mode

INPUT

AUTO PCM DTS

• In the DIGITAL PCM mode

INPUT

AUTO PCM DTS

• In the DIGITAL DTS mode

INPUT

AUTO PCM DTS

• In the ANALOG mode

INPUT

AUTO PCM DTS

One of these lights, depending on the input signal.

DIGITAL ANALOG

DIGITAL

ANALOG

			(Main unit)
4	Start playback on the selected component.
4	• For operating instructions, refer to the component’s manual.
5	Adjust the volume.
	The volume level is
	displayed on the
	master volume level
	display.	(Main unit)	(Remote control unit)

The volume can be adjusted within the range of –70 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 39, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume is adjusted to “18 dB — (Maximum value of channel level)”.)

Input mode when playing DTS sources

•Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “DTS”.

Input signal display

• DOLBY DIGITAL

SIGNAL

DIGITAL

• DTS

SIGNAL

DIGITAL

• PCM

SIGNAL

DIGITAL

The DIGITAL indicator lights when digital signals are being input

properly. If the DIGITAL indicator does not light, check whether

the digital input component setup (page 26) and connections are

correct and whether the component’s power is turned on.

NOTE:

•The DIGITAL indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard.

After starting playback

[1]	Adjusting the sound quality (tone)
1	The tone switches as follows each time the TONE CONTROL
1	button is pressed.
	BASS	TREBLE
	(Main unit)
2	With the name of the volume to be	2 3 1
	With the name of the volume to be
	adjusted selected, turn the SELECT

knob to adjust the level.

	3	If you do not want the bass and treble to be adjusted, turn on
(Main unit)		the tone defeat mode.
		the tone defeat mode.
• To increase the bass or treble: Turn the control clockwise.		The signals do not pass through the
(The bass or treble sound can be increased to up to +12 dB		The signals do not pass through the
(The bass or treble sound can be increased to up to +12 dB		bass and treble adjustment circuits,
in steps of 2 dB.)		bass and treble adjustment circuits,
in steps of 2 dB.)		so it provides higher quality sound.
• To decrease the bass or treble: Turn the control		so it provides higher quality sound.
• To decrease the bass or treble: Turn the control
counterclockwise. (The bass or treble sound can be
decreased to up to –12 dB in steps of 2 dB.)		(Main unit)