Getting Started

Accessories

Check that the following parts are attached in addition to the main unit:

q Operating instructions

......................................................

1

w Service station list.............................................................

1

e Power supply cord (Approx. 1.5 m) ..................................

1

r Remote control unit (RC-1030) .........................................

1

t R6P/AA batteries ..............................................................

3

y AM loop antenna ..............................................................

1

u FM indoor antenna............................................................

1

i Setup microphone (DM-S205) (Approx. 6 m) ...................

1

e

r

t

y

u

i

Before using

Pay attention to the following before using this unit:

Moving the unit

To prevent short-circuits or damaged wires in the connection cables, always unplug the power supply cord and disconnect the connection cables between all other audio components when moving the unit.

Before turning the power switch on

Check once again that all connections are correct and that there are not problems with the connection cables. Always set the power switch to the standby position before connecting and disconnecting connection cables.

Store these instructions in a safe place.

After reading, store this instructions along with the warranty card in a safe place.

Whenever the power switch is in the STANDBY state, the unit is still connected to AC line voltage.

Please be sure to turn off the power switch or unplug the cord when you leave home for, say, a vacation.

Note that the illustrations in these instructions may differ from the actual unit for explanation purposes.

Cautions on installation

Note:

For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure.

Note

Wall

About the remote control unit

In addition to controlling the AVR-2807, the attached remote control unit (RC-1030) can also be used to control the following products:

qDENON component products

wComponent products other than DENON:

Set using the preset memory function ( page 62, 63).

Set using the learning function ( page 64).

Inserting the batteries

qRemove the remote control w Set 3 R6P/AA batteries in

unit’s rear cover.

the battery compartment in

 

the indicated direction.

ePut the rear cover back on.

3

ENGLISH

Getting Started

Notes on batteries:

Replace the batteries with new ones if the set does not operate even when the remote control unit is operated nearby the unit. (The attached batteries are only for verifying operation.)

When inserting the batteries, be sure to do so in the proper direction, following the “<” and “>” marks in the battery compartment.

To prevent damage or leakage of battery fluid:

Do not use a new battery together with an old one.

Do not use two different types of batteries.

Do not short-circuit, disassemble, heat or dispose of batteries in flames.

Remove the batteries from the remote control unit when you do not plan to use it for an extended period of time.

If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

When replacing the batteries, have the new batteries ready and insert them as quickly as possible.

Operating range of the remote control unit

Point the remote control unit at the remote sensor when operating it.

The remote control unit can be used from a distance of up to about 7 meters, at a horizontal angle of up to 30° with respect to the sensor.

30° 30°

Approx. 7 m

NOTE:

It may be difficult to operate the remote control unit if the remote sensor is exposed to direct sunlight or strong artificial light.

ENGLISH