ENGLISH
Easy Setup and Operation
Starting Auto Setup
1 Press the SETUP button.
• The “System Setup” menu appears.
2 Press the CURSOR D or H button to select “Auto
Setup”, then press the ENTER button.
• The “Auto Setup” screen appears.
3 Press the CURSOR D or H button to select “Power Amp Assign”, then press the CURSOR F or G button to select “S. Back”, “ZONE2” or
When “S. Back” is selected, the test tone during Auto Setup will be output from the surround back speaker.
When “ZONE2” is selected, change the setting to “ZONE2”. The test tone during Auto Setup is set so that it will not be output to ZONE2 (Another room).
When
4 Press the CURSOR D or H button to select “Start”, then press the CURSOR F button.
• Start the measurements.
Measurement of each channel is performed as follows:
1 | 2 | 3 |
FL FR | C SW SL | SR SBL SBR |
1: Only the front speakers (A) are measured, front speakers
(B)are not available. Even if the front speakers (B) are set, the setting automatically switches to the front speakers (A) once measurements are completed.
2: The subwoofer speaker is measured twice.
3: When “ZONE2” and
After each channel is measured, “Calculating” appears. The display switches to the Auto Setup check screen automatically.
Easy Setup and Operation
•Measurement is cancelled if the MASTER VOLUME control knob is operated while the Auto Setup is performed.
•If the output volume and crossover frequency of your subwoofer speaker can be changed, then set the volume to halfway and the crossover filter to maximum or switch off the
2About automatic retry
To confirm the results of the measurements, remeasurement is automatically performed.
Remeasurement is performed up to 2 times. During this time, “Retry1” or “Retry2” is displayed on the screen.
NOTE:
•When measurements have been made using the measurement microphone, speakers with
9
ENGLISH