Easy Setup and Operation

ON/SOURCE

POWER SPEAKER A

MODE 1

ENTER

SETUP

CURSOR

ON/STANDBY

SETUP MIC

SPEAKER

ENGLISH

Easy Setup and Operation

Turning on the power

1 Turn on your subwoofer.

2 Turn on your monitor (TV).

3 Press the POWER switch.

¢ON:

The power turns on and the indicator lights.

Set the POWER switch to this position to turn the power on and off from the included remote control unit.

Auto Setup / Room EQ

The Auto Setup and Room EQ function of this unit performs an analysis of the speaker system and measures the acoustic characteristics of your room to permit an appropriate automatic setting.

2Measurement and setting details

q: This sets the speaker connection, polarity, and bass reproduction ability.

w: This sets the delay time from each speaker corresponding to the listening position.

e: This sets the volume that is output from each speaker.

r: This sets the frequency response of each speaker.

For accurate measurements

•Keep quiet during the auto setup procedure. It is recommended that you turn off the power of any air-conditioner, projector or other equipment that may produce noise.

•Do not stand between the microphone and speakers while Auto Setup is performed.

•Do not place any obstacles between the microphone and speakers. Also, be sure to point the speakers towards the listening position.

NOTE:

•A loud test tone is output during the measurement. Please consider this should you be planning night time measurements, and consider not allowing small children into the listening room at this time.

Connecting a microphone

1 Connect the microphone for Auto Setup to the SETUP MIC jack on the front panel of the unit.

2 Place the microphone for Auto Setup at the actual listening position which will be at the same height as your ears.

Microphone

Place the microphone on a tripod or level surface.

£OFF:

The power turns off and the indicator is off.

In this position, the power cannot be turned on and off from the remote control unit.

4 Press the ON/STANDBY switch on the main unit or ON/SOURCE button on the remote control unit.

• Turn on the power.

5 Press the SPEAKER A button to turn the speakers on.

6 Set the MODE 1 switch to “AUDIO” (only when operating with the remote control unit).

8

ENGLISH