17
Chapter 2. Getting Started the BHT-6000 and System Mode
(3) As shown below, slide the battery cover lock in the direction of the arrow and
remove the battery cartridge cover.
(4) Check the polarity (positive and negative) of the battery cartridge. Then, load it so
that the end of the battery pull strap appears above the battery cartridge as
shown below. This facilitates easy removal of the battery cartridge.
(5) Put the battery cartridge cover back into place taking care not to pinch the battery
pull strap between its cover and the bottom cover. Then, return the battery cover
lock to its original position.
Battery cover lock
Battery cartridge
Battery pull strap
Battery cartridge cover
Opening for charge
terminals
The Ni-MH battery cartridge is sold either in a set with its cover or by itself.
Purchase the set with the cover if this is the first time the battery is being used.
NOTE
CAUTION •Do not use batteries or power sources other
than the specified ones; doing so could gener-
ate heat or cause malfunction.
WARNING •Never disassemble or heat the battery cartridge,
nor put it into fire or water; doing so could
cause battery-rupture or leakage of battery fluid,
resulting in a fire or bodily injury.
•Do not carry or store the battery cartridge to-
gether with metallic ball-point pens, necklaces,
coins, hairpins, etc.
Doing so could short-circuit the terminal pins,
causing the batteries to rupture or the battery
fluid to leak, resulting in a fire or bodily injury.
•Avoid dropping the battery cartridge or letting
it undergo any shock or impact.
Doing so could cause the batteries to break,
generate heat, rupture or burn.
•Never charge the Ni-MH battery cartridge where
any inflammable gases may be emitted; doing
so could cause fire.