|
| the FM modulator on/off. |
| ■ | NO FM MODULATOR - FM modulator control is defeated. |
| ■ | This FM Modulator function only applies when the |
|
| RFM100 is connected. |
ANTENNA TV | ■ | Select to choose Antenna or Cable input to TVM300. |
| ■ | Select ANTENNA TV when the TVA10 antenna is con- |
|
| nected to the TVM300. |
| ■ | Select CATV when using a cable TV connection to |
|
| the TVM300. |
CATV STD | ■ | Choose between three types of cable TV setups. |
| ■ | CATV STD - standard cable system for |
| ■ | CATV HRC - for |
| ■ | CATV IRC - for |
Installation
INSTALLATION PRECAUTIONS
1.This product is designed for installation into vehicles with standard
2.All components should be installed in a manner that will not interfere with the normal operation of the vehicle.
3.Route all wires and cables so they cannot be pinched, punctured, or chaffed by sharp metal or screws during reassembly or vehi- cle operation.
4.Disconnect the battery’s negative terminal or remove any fuses from circuits that are affected before the installation.
5.Components should not be installed on areas of high moisture, dust, or heat, and should not be exposed to direct sunlight.
6.All wiring connections should be made using solder and tape or quality solderless connectors. Never leave bare wires. Always terminate unused wires.
7.Before drilling, always check behind panels for clearance to factory wires, hoses, gas tanks, or brake lines.
8.Fuses should only be replaced with like fuses of the same value. If the replacement fuse fails, discontinue operation and contact your authorized retailer.
INSTALLING THE TVM 300
Installing the TVM300 requires working on the PC board of the MCB1000. Only a MECP Certified technician should perform this installation.
1.Disconnect all power wires and cables from the MCB1000 before beginning this instal- lation. Failure to do so could result in fire or damage to the MCB1000 circuitry.
2.Remove the Philips head screws at both ends of the MCB1000 module and remove the cover.
3.Locate the open rectangular area in the corner of the PC board. This is the mount-
10 | © 2001 Directed Electronics, Inc. |