DMS SERIES GUIDELINES

Guidelines

We recommend that you will have the best results by consulting a professional installer, but If choosing to do your own installation, please note the following:

•Make sure all moving parts and factory electrical wires are out of your way and will not interfere after installation.

•Leave a little slack in the wire to prevent pulling or stretching.

•Use adhesive backed tie downs and wire clamps to prevent the wires from getting caught or shorted.

•Correct speaker polarity must be observed. The polarity positive side is marked by a

(+) sign or red. Speaker that are out-of-phase will have little bass output.

•Speaker wire should be isolated from the vessel’s electrical system to avoid noise being picked up by the receiver or amplifier.

•Speaker wire should be large enough to carry the full power of your amplifier. 14 gauge or larger sizes are adequate.

•Be sure to give your ears consideration. Listening to loud music for extended periods can possibly damage your hearing!

TYPICAL INSTALLATION METHOD

6