15”/19“/22” LCD TV
QUICK SETUP GUIDEDX-15L150A11/DX-19L150A11 /DX-22L150A11
HDMI cable
(not included)
HDMI device
Component video device
Component
video cable
Video device S-video cable
Remote
control and 2
AAA batteries
Component
video cable
AC power
cord
TV stand and 4 stando screws
Quick Setup Guide
L/R Audio cable
ANT/CABLE IN
ANT/CABLE IN
ANT/CABLE IN
ANT/CABLE IN
ANT/CABLE IN
ANT/CABLE IN
ANT/CABLE IN
ANT/CABLE IN
ANT/CABLE IN
ANT/CABLE IN
Front and side features
Installing the stand
1 Remove the stand from the box and place it on a table or bench.
2 Lay the TV on a at, cushioned surface.
3 Carefully align and insert the base into the stand until the locking
mechanism clicks into place.
Installing a wall-mount bracket
1 Carefully place your TV screen face-down on a cushioned, clean surface to
protect the screen from damages and scratches.
2 Remove the three screws holding the TV to its stand column, then remove
the stand column.
3 Insert and lock the stando screws (provided) into into the 4 holes on the
back of the TV..
4 Secure the wall-mount bracket to the back of your TV by screwing four M4
screws provided with the bracket into the stando screws you just
installed.
Setting up your remote control
1 While pressing the release button on the battery compartment cover on
the back of the remote, lift the cover o the remote.
2 Insert two AAA batteries into the battery compartment. Make sure that the
+ and – symbols on the batteries align with the + and – symbols in the
battery compartment.
3 Replace the cover.
To program your existing universal remote control to work with your new
Dynex TV, see the table below for common codes. If you have problems
programming your remote or need a dierent remote control code, visit
www.dynexproducts.com for the latest remote control code information.
Connecting a DVD or Blu-ray DVD player, cable
box, satellite receiver or game station
Using HDMI (best)
Connecting an antenna
Connect a 75 ohm cable (not included) to RF jack on the back of your TV and
the RF OUT jack on the antenna.
Connecting a home theater system
Using digital audio cable:
Note: The DIGITAL OUTPUT jack only works with digital TV channels.
Remote
control sensor
Power
indicator
Universal remote control TV codes (for all Dynex TVs manufactured after Jan. 1, 2007)
Philips
PHDVD5, PH5DSS,
PMDVR8, PDVR8
115
DirectTV
RC23
10463
RCA
RCU807
135
One for All
URC-6690
0464
Sony
RM-VL600
8043
Comcast
M1057
0463
Dish Network
VIP508, VIP622
720
Motorola
DRC800
0463
TIVO
Series 3, HD
0091
Universal remote control makers and models Set-top box makers and models
Using S-video (fair)
Using component (better)
Back of TV
Audio Cable
AUDIO IN
Back of TV
Back of TV
Back of TV
Back of TV
ANT/CABLE IN
ANT/CABLE IN
Connecting a Computer
Back of TV