TV components

DX-L24-10A

5

Installing a wall-mount bracket

If you want to attach the TV to a wall-mount bracket (not provided), you should first remove the stand pedestal if it is pre-attached.

To remove the stand column:

1Lay your TV face down on a table or bench. Make sure that you put down a soft cushion or cloth so that your TV is not scratched.

Remove four screws

2Remove the four screws holding the stand column to your TV, then remove the stand and the stand column.

Note: The appearance of this product in these illustrations may differ from your actual product, and is for comparative purposes only.

To attach your TV to a wall-mount bracket:

Warning: These servicing instructions are for use by qualified service personnel only. To reduce the risk of hazards, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

1Remove the four screws holding the TV to its base, as described above.

2Secure the wall-mount bracket to the back of your TV using the four M4*10 screws provided with the bracket.

TV components

Front

#

Component
Description

 

 

 

1

Power indicator

Lights blue when your TV is turned on.

 

 

Lights red when your TV is in standby mode.

 

 

Flashes blue when your TV receives no signal

 

 

from VGA and enters DPMS (Display Power

 

 

Management System) mode.

 

 

No lights when power cord is unplugged.

 

 

For more information, see “Turning your TV

 

 

on or off“on page 12.

 

 

 

2

Remote sensor

Receives signals from the remote control. Do

 

 

not block.