8

Using your TV

Connecting a computer

You can connect a computer using the HDMI or VGA jack on the back of your TV.

Warning: Make sure that you turn off and unplug your TV before installing devices.

Note: When the computer goes into standby mode, your TV turns off. If your TV does not turn on when you “wake” your computer, press the POWER button on your TV or remote control.

To connect a computer using VGA:

1Plug a VGA cable from your computer into the VGA jack on the back of your TV.

PC IN

VGA AUDIO

VGA cable

Audio cable

 

2Plug an audio cable from your computer’s audio out jack into the AUDIO jack on the back of your TV.

3Plug in and turn on your TV.

4Press INPUT repeatedly to select the VGA input source.

To connect a computer using HDMI:

•Plug an HDMI cable into the HDMI INPUT jack on the back of your TV and into the HDMI Out jack on the back of the computer.

Using your TV

Turning your TV on and off

To turn your TV on and off:

1Make sure that the power cord is connected to your TV and a power outlet.

2Press to turn on your TV. The power indicator LED turns green.

3Press again to return your TV to standby. The power indicator LED turns red.

Selecting the TV signal source

To select the TV signal source:

•With the TV on, press INPUT on either the TV or the remote to choose from:

•TV

•Composite

•S-Video

•Component

•VGA

•HDMI

Setting up the channel list

After you select your TV source, if you selected antenna or cable you need to set up the channel list. When you set up your channel list, your TV searches for all available channels in your area and stores a list of these channels. When you press CH – or CH +, your TV skips the channels that do not have a signal.

Automatically setting up channels

To automatically set up the channel list:

1Press MENU. The on-screen display menu opens with Setup highlighted.

 

ENTER

 

 

 

2 Press to enter the sub-menu, then press

or

to highlight

Auto Ch Search.

 

 

3Press ENTER orto start the search.

Note: You can press Exit to stop the search.

Manually adding or deleting channels from the channel list

After you create a channel list using the Auto Ch Search option, you can manually add or delete channels from the channel list.

To add or delete channels:

1Press MENU. The on-screen display menu opens with Setup highlighted.

2Pressto enter the sub-menu, then pressorto highlight Manual Channel Set. The Channel Setup Table opens.

3Pressorto select a channel, then press ENTER to toggle between viewable and not viewable.

4Press MENU or EXIT to close the menu.

Changing channels

To change channels:

•Press CH or CH on the remote control to go to the next lower or higher channel.

Or

Press the number buttons to directly select a channel (for example, if you want channel 83, press 8, then press 3).

Or

Press RECALL to go to the last viewed channel.

Note: HDMI, the HDMI logo, and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.