12 |
Step 6:
Carefully turn your stand over onto its front edges. Unfold the back (G) and lay it over your stand.
Make equal margins along the side and bottom edges of the back (G). Push on opposite corners of your stand if needed to make it “square.”
Fasten the back (G) to your stand using the nails (V).
Note: Make sure that you tap nails into the holes that line up over the upright (C) and shelf (F).
Note: Perforations have been provided for access through the back (G). Carefully cut out the holes needed.
Caution: Do not stand your stand upright without the back fastened. Your stand may collapse.
These holes must line up over the back edges on the upright (C) and shelf (F).
Do not tap nails in this edge
You’ll need:
V (24)
Hammer
Need help? Call