POWER PRUNERTM ATTACHMENT 13

OPERATOR'S MANUAL

3.Slide the cutting attachment onto the shaft housing until the hole in the neck of the cutting attachment is aligned with the hole (C) in the housing (It may be necessary to rotate the saw chain slightly to align the internal pinion and drive shaft.)

4.Insert location bolt (B) into hole (C) and tighten to snug.

5.Tighten bolts (A), clamping the cutting attachment onto the housing.

CB

GUIDE BAR AND SAW CHAIN REPLACEMENT

WARNING

Never try to replace or adjust guide bar and saw chain with engine running. Always disconnect spark plug wire before servicing guide bar and saw chain. This saw chain is VERY sharp, wear heavy gloves to protect your hands when handling it. Wear eye protection meeting CE or ANSI specification Z87.1.

Guide Bar Replacement / Installation

Level2

Tools Required: 10x19mm(13/32x3/4 in.)T-wrench

C

A

B

 

 

 

1.Remove two (2) 6 mm guide bar nuts (A), and turn saw chain tension adjustment slot (B) counterclockwise to release tension.

2.Remove sprocket cover (C).

3.Remove guide bar and saw chain from gear case and sprocket.

4.Remove chain from guide bar and check guide bar for damage and excessive or uneven wear. Replace guide bar if necessary.