39

Recording

The R-09 can be used for recording instrumental performances and taking voice memos, but
it can also be used to record cassettes or CDs using the [LINE IN Jack].

If a device or cable is connected to the [LINE IN Jack], input from the microphones is disabled. Therefore,
it is not possible to mix microphone and line input during recording. If there is sound input via both the
[LINE IN Jack] and the [MIC Input Jack], only the sound from the line input is recorded.

This example describes recording from a CD player to the R-09.

fig.power-onoff-e.eps_80

1.

Turn on power to the R-09.

Turn on the R-09’s power. See “Turning power on/off” (p.
14)

2.

Set the sampling frequency.

“Configuring recording” (p. 26)

fig.open-set-e.eps_80

1. Show the <Menu Screen>.

Press and hold down the [FINDER/MENU Button] to show
the <Menu Screen>.

fig.recoedersetting-e.eps_80

2. Select “Recorder Setup.”

Use the [PLAY Button ] and [STOP Button ] to select
“Recorder Setup,” then press the [REC Button].

fig.setsamplingrate-e.eps_80

3. Select the sampling frequency (Sample Rate).

Use the [RWD Button ] and [FWD Button ] to change
the Sample Rate value.

Recording from cassettes or CDs

Hold down
Hold down
Show
<Menu Screen>
Move the
cursor
up or down Enter
Changes
the value
R-09_e.book 39 ページ 2006年4月6日 木曜日 午後4時51分