Edirol V-8 Storing the Operating Panel Settings

Basic Operation
(continued)
28
You can store the settings of the operating panel buttons and faders in memory locations 2–8 of the [MEMORY] knob. To
recall the stored settings, simply choose the desired memory number.
The factory preset settings are assigned to memory number 1. These settings are recall-only, and can’t be edited.
* The factory preset settings match the button names printed on the operating panel. For details on the settings, refer to
the section “Settings stored at the [MEMORY] knob,” later on this page.
fig.memory-e.eps
Settings for the following buttons and faders are stored at the [MEMORY] knob. The settings you edit are stored immediately
in the currently selected memory number. The on/off states of the EFFECTS buttons are also remembered.
Settings Stored at the [MEMORY] Knob
Operating panel Factory preset
(memory number 1) Stored setting See page
TRANSITION
buttons
[1 MIX]
001: Mix01
Transition effect assigned to each button. p. 36
[2 WIPE] 008: Wipe03
[3 EFX] 192: SWipe88
[BPM SYNC] button
Mode: TransitionA/B
Speed: BPMx1
Transition mode and displayed BPM when using BPM
sync (p. 60). p. 62
Bus A EFFECTS
buttons
[1 (FEEDBACK)] 022: FEEDBACK ✽
Effect setting assigned to each button. p. 53
[2 (NEGATIVE)] 033: NEGATIVE ✽
[3 (COLORIZE)] 042: COLORIZE ✽
[4 (MULTI)] 126: MULTI-HV ✽
Bus B EFFECTS
buttons
[1 (FLIP)]
102: FLIP ✽
[2 (CHROMA KEY)] 098: CHROMAKEY ✽
[3 (LUMINANCE KEY)] 096: B-LUMIKEY ✽
[4 (P in P)] 150: PinP ✽
Bus A [TRANSFORMER] button 02: Trans Settings for operating the [TRANSFORMER] buttons. p. 41
Bus B [TRANSFORMER] button 02: Trans
[OUTPUT FADE] fader 02: Manual Fade operation setting for the [OUTPUT FADE] fader. p. 78
PANEL MODE 01: Video + MidiOut Settings for whether MIDI messages will be
transmitted when buttons or faders are operated. p. 67
Storing the Operating Panel Settings ([MEMORY] Knob)
234578
6
1
V-8_e.book 28ページ ２０１０年４月１６日 金曜日 午後５時１４分