Platform Interface Module

GigE Triple Play PIM

PIM 41S/D-GigE
General
Operation Modes

BERT, IP QoS, RFC2544, Monitor, Service Tool and NIC for Triple Play Analysis Suite–IPTV, VoIP, Data

Physical Interfaces

Single or Dual 10/100/1000Base-T Electrical UTP (RJ-45) and 1000Base-X Optical (SFP) port

Standard SupportedIEEE 802.3 2005 ComplianceLED IndicatorsModule: On or OffIF/LB: SFP (Optical), UTP (Copper) or loop backLink: Signal or Loss (SFP), Link Up or Down (UTP)Speed: 1G (SFP), 10M, 100M or 1000M (UTP)Sync: Pattern Sync/Loss (BER) or ErrorLaser: Laser On or Off
Port Operation
Single Port A (Term./LB, Monitor)Single Port B (Term./LB, Monitor)

Dual Port A and Port B (Term./LB, Mon, PassThrough) Port in Electrical or Optical

Traffic Generation
Physical

Configurable Speed, Duplex, Flow Control (Auto/Manual), and Remote Loop back L1/L2/L3

IP VersionIP V4 or IP V6Frame FormatsEtherType II (DIX v.2)IEEE 802.3–LLC1 and IEEE 802.3–SNAPLayer 1, MAC, MAC+IP, MAC+IP+UDPStreams

Up to 256 multi-streams per port in Uniform Traffic Profile

-Source/Destination MAC/IP and VLAN addresses with traffic load averagedUp to 4 multi-streams per port in Individual Traffic Profile-Addresses, Prioritization/IP header, Frame size, Payload, Traffic loadAddressesSource/Destination MAC/IP and VLAN ID (Single/Stack Q-In-Q), ARP/DHCP supportedPrioritizationVLAN ID (802.1Q)/Priority (801.p), and IP TOS/Cisco DiffServ DSCPIP HeaderPrioritization, TTL, UDP/TCP/HOPOPTTraffic Load

Up to full wire speed in Line Utilization %, Line Rate in Kbps, Frame Rate in FPS and Frame Gap

Frame Size64~2040 Bytes, including Under/Oversize and JumboDurationInfinite, the Number of Frames, and Timed
March 2008

Specification Sheet

PayloadPRBS, CJPAT, CRPAT, All-0s, All-1s, ALT1/0ShapingConstant, Ramp and BurstError InsertionBE (BERT), CRC, IP Checksum and Alignment
QoS Test
Operation

IP QoS test in asymmetric or symmetrical testing Remote Loop back with MAC/IP S/D addresses swapped automatically

QoS Index Inserted

Anacise QoS Test Payload with sequence no. and timing inserted for the validation of Triple Play service

Timing Resolution40 ns for all timing parameter measurements

Payload

215-1, 220-1, 223-1, and 231-1, with pattern inverted optionQoS Measurements

Network Delay in ms (Current, Min, Max, and Avg) Inter-Arrival Time (Current, Min, Max, and Avg) Jitter Distribution Analysis Diagram

Packet Loss (Count, Ratio)Out of Sequence (Count, Ratio)

QoS result is classified per the standard of ITU-T Y.1541 Network Performance Objectives for IP-Based Service

Traffic StatisticsSame as the traffic statistics–Physical and Frame layer in Monitor mode
Multi-BERTs

Operation

Single BERT with Uniform multi-streams in P-t-P, P-t-LB Multi-BERTs with Individual multi-streams in P-t-P, P-t-MP and P-t-LB

BER Testing in Asymmetrical or Symmetrical testing Loop back with MAC/IP source/destination addresses swapped automatically

Patterns

215-1, 220-1, 223-1, and 231-1, with pattern inverted option Long Continuous Random Test Pattern (CRPAT)

Long Continuous Jitter Test Pattern (CJPAT) All-0s, All-1s, ALT1/0BER ResultsIndividual Stream-based :

BER count/BER %, Frame sync loss count/time, Pattern Sync Loss time, BER frames received, Utilization% and FPS

Port-based :

CRC error count/rate, IP checksum error count/rate, Packet loss, Sequence error, Alignment, Line-rate

Traffic Statistics

Same as the traffic statistics–Physical and Frame layer in Monitor mode

GigE Triple Play PIMPage 1 of 2