If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
●No picture problems : See No.1 ~ No.2
●Imaging problems : See No.3 ~ No.14
●Other problems : See No.15 ~ No.18
●USB problems : See No.19 ~ No.20
Problems | Points to check with possible solutions | |
1. No picture | [ ] Check that there is nothing left on the face of | |
| Power switch. Wipe the control panel, and | |
Status of Indicator lamp "ON" | then touch the Power switch again with dry | |
finger. | ||
is off. | ||
Check that the power cord is correctly | ||
| ||
| connected. | |
| If the problem persists, turn off the monitor | |
| power for a few minutes, then turn it back on | |
| and try again. | |
Status of Indicator lamp "ON" | [ ] Check the Gain setting. | |
is light. |
| |
Status of Indicator lamp "Power | [ ] Switch the signal Input by touching the input | |
Save" is light. | signal selection switch on the front control | |
| panel. | |
| [ ] Try touching a key on the keyboard, or | |
| clicking the mouse. | |
|
| |
2. Following messages | These messages appear when the signal is not | |
appear. (Error messages | inputted correctly, even if the monitor | |
shown below will remain | functions properly. | |
on the screen for 40 | [ ] When the image is displayed correctly after a | |
seconds.) | short time, there is no problem with the | |
monitor. (Some PCs do not output the signal | ||
| ||
| soon after powering on.) | |
| [ ] Check that the PC is turned ON. | |
| [ ] Check that the signal cable is properly | |
| connected the PC or graphics board. | |
| [ ] Switch the signal input by touching the Input | |
| Signal Selection switch on the control panel. | |
|
| |
|
|