Solution
Set higher position.
Pre-cool the appliance for enough time.
Cut up food.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the four
feet should be on the floor).
Problem
The appliance does not cool
sufficiently
The appliance cools too hard
The appliance does not cool
at all
The appliance is noisy
Possible cause
Thermostatic control is set too low.
Before freezing the appliance was not precooled
sufficiently.
Large-sized food was put in.
Too many foods to be frozen were put in.
Warm foods were put in.
Door is not shut properly.
The thermostatic control is set too high.
Plug is not connected to the mains socket
properly.
There is no voltage in the mains socket.
Thermostatic control is in 0 position.
The appliance is not supported properly.
23

When the refrigerator is not in use

In case the appliance will not be used for a long time
follow these steps:
Remove plug from the mains socket.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
During operation of the appliance some smaller but
annoying trouble can often occur, which does not
require calling a technician out. In the following chart
information is given about them to avoid unnecessary
charges on service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating
sound). This is not trouble, but means normal
operation.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-
current. That is why you must not touch the electrical
parts of the appliance before removing it from the
mains socket.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
GB