29 electrolux operation test
Operation test
Perform test operation after completing gas leak check at the flare nut connections and electrical safety check.
preparing the device for operation electrolux 30
Preparing the device for operation
1. | Contact a specialist to install the device. |
2. | Guarantee that the unit is appropriately fastened and complies with all of |
the aforementioned safety norms. |
1.Connect the power, press the ON/OFF button on the remote controller to turn the unit on.
2.Use the MODE button to select COOL, HEAT, AUTO and FAN to check if all the functions works well.
3.When the ambient temperature is too low(lower than 17ºC), the unit
cannot be controlled by the remote controller to run at cooling mode, manual operation can be taken. Manual operation is used only when the remote controller is disable or maintenance necessary.
3. | Before operating the air conditioner, ensure that the air filter is installed |
correctly. | |
4. | If the unit has been out of use for a long period of time, it is recommended |
that the air filter be cleaned before use. During continuous use, clean the air | |
filter every two weeks. | |
5. | This air conditioner was designed for use under the following conditions: |
MODE
Cool | Heat | Deshumidifier | |||
Room Temperature | Room Temperature | Room Temperature | |||
Indoor | Outdoor* | Indoor | Outdoor | Indoor | Outdoor |
17°C~32°C | 18°C~43°C | 17°C~30°C | 17°C~32°C | 11°C~43°C |
*
Auto/Cool
or | Manual control button |
Manual control button
Auto
Cool
If air conditioner is used outside of the above conditions, certain safety protection features may come into operation and cause the unit to function abnormally. Room relative humidity less than 80%. If the air conditioner operates in excess of this figure, the surface of the air conditioner may attract condensation. Please sets the vertical air flow louver to its maximum angle (vertically to the floor), and set HIGH fan mode.
Optimum performance will be achieved within these operating temperature.