Electrolux ESOGBR, ESOGSS, ESOGWH BCD

To replace the gas grill burner injector, follow this

procedure:

1. Undo the two fixing screws (“A”) which keep the gas

grill burner in place

2. Gently slide the gas grill burner off its slot and slowly

move it downwards, taking care not to cause stress

to the spark candle connection wire (“B”) and the

thermocouple (“D”) conductor;

3. With a 7 mm socket spanner unscrew and remove

the gas grill burner injector (“C”), and replace it with

the required one (see Table on this page);

4. Reassemble the burner following the same procedure

backwards.

The gas grill burner does not need any

primary air regulation.

GAS INJECTOR NOMINAL NOMINAL GAS REDUCED BY-PASS NOMINAL

TYPE MARK GAS FLOW IN GAS NEEDLE GAS

1/100 mm POWER POWER (1/100 mm) PRESSURE

(kW) m3/h g/h (kW) (mbar)

098 1,9 0,181 - - - 20

71 1,9 - 138 - - 28-30 / 37

BCD

Once both the injectors for the gas oven burner and the

gas grill burner have been replaced, take the Gas Type

Sticker which is relevant to the new gas type and place

it over the old one (it is located near the gas connection

ramp). The replacement sticker is supplied with the

injector kit.