6 DH 315
Planing workpieces
3The planer can remove max. 3 mm material
in one pass. This capacity, however, shall
only be utilized:
-with very sharp planer knives;
-with soft timber;
-if the max. planing width is not utilized.
Otherwise there is a risk of overloading the
machine.It is best to make several passes,
until the workpiece has the desired thick-
ness.
Workpiece dimensions
1. Fold both infeed and outfeed table down.
2. Set planing thickness with the crank.
ARisk of kickback!
Set the planing thickness only with the cut-
terblock at standstill!
3. Start motor (press green switch button).
4. Feed workpiece slowly over the planer bed.
The workpiece is fed automatically.
5. Guide workpiece in a straight line through the
machine.
ARisk of personal injury!
Never reach with your hands inside the
machine while guiding a workpiece! Guide a
workpiece from the outfeed end, when it is
drawn so far into the machine that it can no
longer be safely guided from the infeed side.
6. Switch the machine off, if no further planing is
to be done immediately afterwards.
Care and maintenance
ADanger!
Prior to all servicing:
-Switch machine OFF.
-Unplug power cable.
-Wait until the saw has come to a complete
stop.
·Check that all safety devices are operational
again after each service.
·Replace defective parts, especially of safety
devices, only with genuine replacement parts.
Parts not tested and approved by the equip-
ment manufacturer can cause unforeseen dam-
age.
·Repair and maintenance work other than
described in this section should only be carried
out by qualified specialists.
Alignment of infeed and outfeed table
1. Fold both infeed and outfeed table down.
2. Place a straight board, steel ruler or straight
edge across both infeed and outfeed table:
-The board / straight edge must rest on both
rollers and must not sag in the middle.
-Infeed and outfeed table are correctly set if a
sheet of paper will just fit between board/
straight edge and thicknesser bed.
length width height
min. 130 mm min. 64 mm min. 5 mm
over 1500 mm
use additio-
nal workpiece
support
max. 318 mm max. 153 mm
DO
WN
UP
DO
WN
UP