
1 Introduction
This software manual describes step by step how to operate successfully with the ½ 19"
and 19" MLT analyzer module and analyzer of the NGA 2000 Series. Chapter two shows the structure of the MLT software menus. Chapter three describes the display and the keyboard of the analyzer. Chapter four describes the basic controls with detailed illustrations. So you can easily compare the actual display of the analyzer module with the illustrations of the manual.
Chapter five describes the expert configurations of the analyzer module and of the Input/ Output Modules (I/O modules). Chapter six describes the system configuration. The layout of both chapters is not as detailed as in chapter four. Normally, the way to a certain menu of the MLT software is described with the software catchwords you have to press to reach this menu. You will find the illustration of the corresponding LCD screen at the end of the catchword listing. After that you can read the meaning of the functions and variables of each expert or system configuration menu.
Some contents of the expert configurations are not important for each customer. It depends on the configuration of your NGA 2000 system, relative to the following components:
♦ Control Module | CM |
♦ Analyzer Module | AM |
♦Input/Output Modules I/O's (SIO =Standard I/O, DIO = Digital I/O,
System Auto Calibration I/O, Analog Output with 3 Alarms I/O,
Auto Calibration I/O)
You can distinguish the following system units and SIO/DIO configurations:
System Unit | Section | ||
Page | |||
|
| ||
MLT analyzer module (AM): | ⇒ 1 local SIO and 1 local DIO can be |
| |
∙ without front panel, | installed in the MLT analyzer |
| |
module |
| ||
i.e. without control unit | |||
⇒ SIO and DIO can be configured | |||
∙ can be combined with a platform, | |||
p. | |||
for the channels of the analyzer | |||
an MLT analyzer, a TFID analyzer | |||
| |||
module only |
| ||
or a customer developed control |
| ||
|
| ||
unit |
|
| |
Platform (CM Software): | ⇒ 1 SIO and up to 4 DIO's can be |
| |
∙ Control unit with front panel | installed in the platform (CM I/O) | ||
⇒ SIO and DIO can be configured | |||
∙ Without measurement channels | p. | ||
for all channels combined with the | |||
|
| ||
| platform |
| |
MLT analyzer (CM and MLT AM | ⇒ 1 SIO and 1 DIO can be installed |
| |
software): | in the MLT analyzer (CM I/O) |
| |
∙ Analyzer with front panel | ⇒ SIO and DIO can be configured | ||
|
∙ CM and AM software in the same | for all channels combined with the | p. | |
MLT analyzer | |||
analyzer, | |||
| |||
|
| ||
i.e. all functions of the control unit |
|
| |
and of the AM are combined in one |
|
| |
controller board |
|
|
90003482(2)
NGA 2000 | 1 - 1 |