The playback function uses all 4 switches. NOTE that you must be in the OFF state to re-enter the record mode. The REW and FWD switches have different meaning when in PLAY or PAUSE. Note that “playback” does not erase any data. Once you are finished with local “playback”, you may continue recording from where you left off by first turning the RECORDER “off” then pressing RCD. The HAWK8/A and FALCON4 do not have PLAYBACK capability.

PLAY / PAUSE

NOTE!

The Play / PAUSE (P/P) as well as the REW(R) controls on the HAWK unit is on the bottom. Use a paper clip to operate and hold down button until recording plays (3-5 seconds).

The "PLAY" button causes the unit to power up, turn the green LED 'ON" and start playing from the beginning Session 1. Depressing this switch while the unit is playing will cause it to PAUSE and flash the green LED. To continue playing you must depress this switch again.

REW

Depressing this switch while the audio is playing causes a 3-minute jump back. Depressing it while you are in PAUSE causes the RECORDER to begin playing from the beginning of the current Session. To jump back into the previous session you should hit REW from the PAUSE state, and then hit REW again to take you back into the previous session.

FWD

Depressing the "FWD" switch causes the audio to jump ahead 3 minutes. If you are in the PAUSE state, depressing this switch will jump you into the beginning of the next Session.

OFF

Depressing this button will cause the recorded to be powered OFF. This must be done to re-enter the RECORD mode.

RECORDING LENGTH

Type of camera and frames per second determines the recording length. The chart below displays HAWK recording duration. The settings are stereo with 2:1 compression. Times are given for each session and full recorder length.

39