3.2.3. Removing the Printhead
1. Remove the printer cover andribbon cartridge (seeSection 3.2.1).
2. Remove 2 CBS screws (3×10, F/Zn) securing theprinthead to theCR assembly.
3. Remove the printhead from theCR assembly.
4. Disconnect 2 wide FFCsfrom the printheadand thendisconnect the narrow FFC fromthe
connector on theCR cover.
The FFC must be connected properly, as shown in the following figure.
The tightening torque for the 2 CBS screws (3 ×10, F/Zn) = 0.59 ~ 0.78 Nm ( 6 ~8 Kg f. cm )
Adjust the platen gap. Refer to Chapter 4.