1.Press the 
Operate button. The Operate light comes on and the print head moves.
2. Open the document and maintenance covers, if necessary.
3.Unwrap the ink cartridges. Then pull off only the yellow part of the tape seal on top. Don’t pull
off the blue portion or remove the clear seal on the bottom of the cartridge.
| WARNING | If ink gets on your hands, wash them thoroughly with |
| soap and water. If ink gets in your eyes, flush them |
immediately with water. Keep ink cartridges out of the reach of children.
4.Lift up the ink cartridge clamps.
5. Insert the ink cartridges with the labels
6. Press down on the ink cartridge clamps until they lock into place.
7.Close the maintenance and document covers.
8. Press the 
cleaning button to begin charging the ink delivery system.
Charging takes about 2 minutes. The 
Operate light flashes and the printer makes various sounds. Don’t turn off the printer yet. Wait until the 
Operate light stops flashing and stays on.
CAUTION | Don’t open the clamps to remove a cartridge except to |
| |
| replace it with a new one. Once you remove a cartridge, |
|
you can’t reuse it, even if it contains ink. You must install both cartridges and leave them installed for all types of printing. To avoid damaging the printer, never move the print head by hand.
1.Slide out the edge guide.
2. Slide out the tray extension.
3.Place a stack of
paper against the right side of the feeder.
4. Make sure the paper fits under the arrow mark inside the edge guide. Slide the edge guide against the paper.
7Test yourEPSON Stylus Scan1. Turn off the printer.
2.Hold down the 
load/eject button.
3. Press the 
Operate button.
When you release the buttons, the nozzle check page starts to print. This is what it should look like:
If it doesn’t look right, you may need to run a print head cleaning cycle. See your User’s Guide for instructions. If it doesn’t print, see “Solving Problems” in your User’s Guide.