Epson PowerLite 750c/760c Projector

❏Or press the Menu button, select the Setting menu, and press Enter.

From the Setting menu, select Keystone and press Enter. Use the pointer button on the remote control to adjust the keystone setting as needed. The keystone setting is adjustable from –65 to +65. These numbers represent a range of –30° to +30° of angle change; adjustments are made in steps of 0.5°.

Note:

The image will be slightly smaller after adjusting.

Adjusting the Brightness

The brightness of an image depends on the source you are projecting and the amount of light in the room. If the image is too bright or not bright enough, do one of the following:

❏Change the Brightness setting in the Image menu.

❏Select Low or High for the Brightness Control option in the Setting menu. Low Brightness mode extends the life of the lamp and decreases the fan noise.

Adjusting the Color Mode

You may want to adjust the Color Mode option to select a setting that is appropriate for the image you’re projecting and the environment in which you’re projecting it.

The following table lists the available color modes.

Color mode Description

To change the color mode, press the Color Mode button on the remote control until you see the mode you want. The currently selected setting appears in the upper right corner of the screen. You can also use the projector menu system to select the Color Mode setting in the Image menu.

Correcting Computer Images

If you’ve connected a computer and the image doesn’t look right, or it doesn’t fit properly on the screen, press the Auto button on the remote control or the Enter button on the projector. This automatically resets the projector’s tracking, sync, resolution, and position settings.

Note:

You must be projecting an image for this button to have any effect. Additionally, if the Auto Setup option in the Signal menu is set to OFF, the Auto function will not work.

If the Auto button doesn’t correct the problem, you may need to adjust the tracking or sync using the projector’s Signal menu.

Sleep Mode

When the projector has not received any input signals for

30 minutes, it automatically turns off the projector lamp and enters “sleep mode.” This conserves electricity, cools the projector, and extends the life of the lamp. If you are done using the projector, unplug the power cord. If you want to start projecting again, press the P Power button.

You can enable sleep mode in the Extended menu under Operation.

Using Direct Power On

The Direct Power On function enables faster setup. The projector will start up automatically when you plug it in; you

sRGB

For matching the color palette of standard sRGB computer displays.

won’t have to press the P Power button.

Dynamic

For increased brightness in bright rooms (the default for non-computer display).

Follow these steps to enable Direct Power On:

1. Press the Menu button on the remote control and select the

Presentation

For computer presentations (the default when projecting from a computer with analog video).

Extended menu.

2. Choose Operation and press Enter.

Theatre

For optimizing movie images with increased contrast.

3. Choose Direct Power On and press Enter.

Living Room

For increased brightness when playing video games or watching TV in a bright room.

Blackboard

For projecting accurate colors on a green chalkboard (adjusts the white point).

6 - Epson PowerLite 750c/760c Projector

8/05