EPSON Stylus Photo 785EPX

Printable area

A

 

A

 

B-L

B-R

B-L

B-R

 

C

 

 

 

 

 

 

envelopes

 

C

 

 

single sheets/index cards

 

 

**no margins

(4 ⋅ 6, 5 ⋅ 7, 8 ⋅ 10, and letter-size only)

A:The minimum top margin is 0.12 inch (3.0 mm).

When loading multiple sheets of EPSON Photo Quality Glossy Film, the minimum top margin is 1.2 inches (30.0 mm).

B-L: The minimum left margin is 0.12 inch (3.0 mm).

B-R: The minimum right margin is 0.12 inch (3.0 mm) for all papers except DL envelopes (0.28 inch [7.0 mm]) and No. 10 envelopes (1.10 inches [28.0 mm]).

C:The minimum bottom margin is 0.55 inch (14.0 mm).

*You can extend the minimum bottom margin to 0.12 inch (3.0 mm) by selecting Maximum as the Printable Area setting. However, print quality may decline in the expanded area.

**When printing with the No Margins setting, print quality may decline in the top and bottom areas of the printout.

Control Panel

To diagnose some problems, check the printer’s control panel, as described below, or run a printer check (page 6).

Green

The printer is receiving a print job,

Processing

reading a PC card, printing, or performing

light flashes

maintenance procedures.

Red blight

Your paper ran out, ink ran out, or paper

is on

is jammed. You may also see one of the

 

messages shown at the left, or a

 

message on your screen.

 

❏ If paper is out, load more paper, then

 

press the bmaintenance button to

 

resume printing.

 

❏ If paper is jammed, press the b

 

maintenance button to eject the

 

paper. If that doesn’t work, turn off

 

the printer, open the printer cover,

 

and remove all the paper, including

 

any torn pieces. Then turn on the

 

printer, reload paper, and press the

 

bmaintenance button.

 

❏ If you’re printing on roll paper, press

 

the z roll paper button for at least

 

three seconds to clear the jam.

 

❏ If you see IEb (Ink Empty black) or

or

IEc (Ink Empty color) on the control

panel, you need to replace one of

 

your ink cartridges. Replace the

 

cartridge as described on page 7.

 

❏ If you see IC (Ink Cartridge) on the

 

control panel, one of the cartridges

 

is not installed correctly. Remove it

 

and install it correctly, as described

Red blight

on page 7.

One of the ink cartridges is low. Make

flashes

sure you have a replacement cartridge.

or

Check the message that appears on your

 

screen or on the control panel to see if

 

you need a black (ILb) or color (ILc)

 

cartridge.

Green

Press the bmaintenance button, then

Processing

remove any paper in the printer. Turn off

light flashes

the printer, open the cover, and remove

and red b

any paper or other foreign objects. Make

light is on

sure there is sufficient space around the

 

vents on the back of the printer. Then

 

turn the printer on again. If the lights are

 

still on, contact your dealer or EPSON.

Green

An unknown printer error has occurred.

Processing

Turn off the printer and contact your

light and red

dealer or EPSON.

blight

 

flash

 

Red blight

Internal printer parts need adjustment or

flashes

replacement. Turn off the printer, wait a

 

few seconds, then turn it back on. If you

Red blight

still see the error, contact EPSON.

The memory card is damaged or the data

flashes

is corrupted. Try reformatting the card in

 

your camera.

4 - EPSON Stylus Photo 785EPX

4/01