825 |
|
Photo | EPSON Stylus® Photo 825 |
|
EPSON Stylus | Start |
Here | |
|
1Unpack
1 Remove everything from the box.
Ink cartridges | Printer Software |
|
Printer | Paper support |
CompactFlash™
card adapter
Roll paper | Roll paper | Printer Basics | Quick Reference |
holders | adapter | book | card |
adapter
2 Remove the tape and packing material.
Peel off the plastic film
2 Attach the Paper Holders
1 Slide the paper support into its three slots on the back of the printer.
2 Slide the roll paper adapter behind the paper support, into the two slots on the back of the printer.
NOTE: For information on loading and printing on roll paper, see your Printer Basics book.
3 Insert the tabs on the roll paper holders into the slots on the back of the printer.
3Turn On the Printer
1 Plug the printer’s power cord into a grounded electrical outlet.
2 Press the dark gray 
power button to turn on the printer.
4 Install Ink Cartridges
1 Open the output tray.
2 Open the printer cover.
4 Unpack the ink cartridges that came with your printer and remove the yellow tape from the top.
CAUTION: Install both ink cartridges and leave them installed for all types of printing, or the printer won’t work.
5 Tilt each cartridge toward you as you lower it into the holder.
Make sure the tabs rest on the hooks in the back.
6 Lower the clamps so they snap shut.
7 Press the 
ink replacement button and close the cover.
The green light flashes as your printer charges ink for about 21/2 minutes.
CAUTION: Don’t turn off the printer or interrupt charging while the green light is flashing or you’ll waste ink.
5 Load Paper
1 Load some paper against the right side of the feeder (up to the arrow inside the edge guide).
2 Press in the tab on the edge guide and slide it to fit lightly against the paper stack.
3 Pull out the output tray extensions.
6 Connect the Printer
1 Make sure you have a USB cable (not included with your printer).
2 Plug the 
square end of the USB cable into your printer’s USB port.
3 | Peel off the tape beneath the cover | 3 | Lift up both ink cartridge clamps. |
| and remove the insert. |
3 Plug the 
flat end of the cable into any available USB port on your computer.
Continue | Turn over |