EPSON Stylus Photo 875DCS
Environmental
Temperature |
|
Operation | 50 to 95 °F (10 to 35 °C) |
Storage* | −4 to 140 °F (−20 to 60 °C) |
| 1 month at 140 °F (60 °C) |
Transit* |
|
| 120 hours at 140 °F (60 °C) |
Humidity (without condensation) | |
Operation | 20 to 80% relative humidity |
Storage* | 5 to 80% relative humidity |
*Stored in shipping container
Safety Approvals
Safety standards | UL 1950, CSA C22.2 No. 950 |
EMC | FCC part 15 subpart B class B |
Control Panel
paper out |
|
|
light |
| power |
color ink |
| |
| light | |
out light |
|
|
black ink |
|
|
out light |
|
|
cleaning | load/eject | power |
button | button | button |
Follow these guidelines when you check the control panel lights.
P is on | The Ppower light is on when the printer is ready |
| to print. It flashes when the printer is receiving a |
| print job, charging ink, or cleaning the print head. |
|
|
S flashes | When the S paper out light flashes and both ink |
and | out lights come on, you have a paper jam. Press |
B and A | the E load/eject button to try to clear the jam. If |
are on | that doesn’t work, turn off the printer and gently |
| pull pull the paper forward (toward the output tray) |
| to pull it out. Don’t pull the paper backward |
| (toward the paper support). If you can’t pull it out |
| through the output tray, contact your dealer or |
| EPSON. Make sure none of the sheets are curled, |
| creased, old, stuck together, or too thin. Then |
| reload the paper against the right edge guide and |
| slide the left edge guide against it. Turn on the |
| printer and press the E load/eject button to resume |
| printing. |
|
|
S is on | When the S paper out light comes on, your paper |
| is out or incorrectly loaded. Make sure none of the |
| sheets are curled, creased, old, stuck together, or |
| too thin. Then reload the paper against the right |
| edge guide and slide the left edge guide against it. |
| Press the E load/eject button to resume printing. |
|
|
B or A flash | When an ink out light flashes, your ink supply is |
| low. Make sure you have a replacement cartridge. |
|
|
B or A are on | When an ink out light comes on, you need to |
| replace the ink cartridge. Make sure you have a |
| replacement cartridge. See page 9 for instructions. |
| If an ink out light comes on after you’ve replaced a |
| cartridge, you installed a cartridge your printer |
| can’t use. Remove it and replace it with the |
| correct type (see page 4 for ink cartridge |
| specifications). |
|
|
P and S | When the Ppower and S paper out lights flash |
flash and | and one or both of the ink out lights come on, |
B and A | jammed paper may be blocking movement of the |
are on | print head. Turn off the printer, open the cover, |
| and check inside for any jammed paper. Then turn |
| the printer back on. If the lights still flash and/or |
| come on, contact your dealer or EPSON. |
|
|
P S B A | When all the lights flash, your printer may have an |
flash | internal error. Make sure you removed all the |
| packing material as described on the unpacking |
| sheet in your printer box. Then turn off the printer, |
| wait a few seconds, and turn it on again. If the |
| lights still flash, contact your dealer or EPSON. |
|
|
P S B A | When all the lights are off, the printer is not |
are off | receiving power. Try these solutions: |
| ❏ Make sure the printer is turned on. |
| ❏ Turn off the printer, plug in the power cord |
| securely, and turn on the printer again. |
| ❏ Make sure the outlet is operable and is not |
| controlled by a switch or timer. If in doubt, try |
| using another outlet. |
|
|
Installing an Ink Cartridge for the First Time
Follow these ink cartridge precautions and the others in the Printer Basics book:
❏Install both ink cartridges, and leave them installed for all types of printing, or the printer won’t work.
❏Remove the yellow tape seal from the top of the ink cartridges or you’ll permanently damage them. Don’t remove the clear seals on the bottom or ink will leak out.
❏Don’t touch the green chip on the back of the cartridge. This may inhibit normal operation and printing.
❏Never turn off the printer when the P power light is flashing, unless the printer hasn’t moved or made any noise for more than five minutes.
5 - EPSON Stylus Photo 875DCS | 9/00 |