900

 

PhotoEPSON Stylus® Photo 900

 

EPSON Stylus

Start

Here

 

 

CPD-15860R1

1 Unpack

1 Remove everything from the box.

Paper support

Ink cartridges

Printer Software

Printer

 

CD-ROM

 

 

Roll paper holders

CD tray

CD check disk

Printer Basics

2 Remove all the blue tape and packing materials inside and around the printer.

2 Attach the Paper Support

Insert the paper support into its slots on the back of the sheet feeder.

(To install the roll paper holders, see your Printer Basics book.)

3 Connect the Printer

Connection cables are not included with your printer. You need only one of the following cables:

USB cable (PC and Mac®) or

Parallel cable (PC only)

USB Cable Users (PC and Mac)

1 Shut down your computer. In Windows®, click Start and select your Shut Down or Turn Off option.

Leave your computer turned off until section 7.

2 Plug the square end of the cable into your printer’s USB port until it stops.

3 Plug the flat end of the cable into your computer’s USB port until it stops. (You can use any open USB port.)

Square end Flat end

Parallel Cable Users (PC only)

1 Shut down your computer. In Windows, click Start and select your Shut Down or Turn Off option.

Leave your computer turned off until section 7.

2 Plug the end of the cable with the slotted connector into your printer’s parallel port, then secure it with the wire clips.

3 Plug the other end of the cable into your computer’s parallel port and secure it with the screws.

4 Turn On the Printer

1 Plug the printer’s power cord into a grounded electrical outlet.

power button

2 Press and release the power button to turn it on.

CAUTION: Never use an external switch, such as a wall switch or power strip switch, to turn the printer on or off.

5 Install Ink Cartridges

1 Open the output tray and the printer cover. Then lift up both ink cartridge clamps.

2 Unwrap the ink cartridges and remove the yellow tape.

Don’t touch the green part

3 Lower each cartridge into the holder. Make sure the tabs rest on the hooks in the back.

CAUTION: You must install both cartridges or the printer won’t work.

4 Press down on the ink cartridge clamps until they click into place.

5 Close the printer cover.

6 Press theink button.

3 Open the printer cover and remove the plastic piece from the ink cartridge holder.

Remove

Slotted end

End with screws

The green power light flashes as your printer charges ink for about 2 minutes.

CAUTION: Don’t turn off the printer or

 

interrupt charging while the power

Ink button

light is flashing or you’ll waste ink.

 

Turn over