Epson AVR-687 19

ENGLISH

Connecting Other Sources

Connecting the antenna terminals

An F-type FM antenna cable plug can be connected directly.

Direction of broadcasting station
	AM loop antenna
FM antenna	(Supplied)

NOTE:

•Do not connect two FM antennas simultaneously.

•Even if an external AM antenna is used, do not disconnect the AM loop antenna.

•Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.

Connecting Other Sources

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

75 Ω/ohms Coaxial cable

FM indoor antenna (Supplied)

Connecting the XM terminal

•AVR-687 is the XM Ready® receiver. You can receive XM® Satellite Radio by connecting to the XM Passport System (sold separately) and subscribing to the XM service.

•Plug the XM Passport System into XM terminal on the rear panel.

•Position the XM Passport System near a south-facing window to receive the best signal.

For details, see “XM Satellite Radio” ( page 32).

When making connections, also refer to the operating instructions of the XM Passport System.

XM Passport System

AUX OUT

AM outdoor antenna

Ground

¢AM loop antenna assembly

Connection of AM antennas

Remove the vinyl tie and take out the connection line.

a. With the antenna on top any stable surface.

Mount

b. With the antenna attached to a wall.

Connect to the AM antenna terminals.

Bend in the reverse direction.

1. Push the lever.

2. Insert the conductor.

3. Return the lever.

NOTE:

•Keep the power supply cord unplugged until the XM Passport System connection has been completed.

Installation hole Mount on wall, etc.

ENGLISH