ENGLISH
Advanced Operation
INPUT SELECTOR
<POWER> <SPEAKER>
INPUT SELECTOR 
Recording the program source (recording the source currently being monitored)
1 Select the input source to be played.
2 Select the input mode and play (surround) mode.
3 Start recording on the tape or video deck.
For instructions, refer to the component’s operating instructions.
•The AUDIO IN’s signal selected with INPUT SELECTOR are output to the
•Digital signals are not output to the audio output terminals.
Advanced Operation
About the memory functions
¢Last function memory
The various settings set when the
¢Backup memory
The various settings are stored in the memory for about 1 week, even when the power is turned off or the power cord is unplugged.
Initialization of the microprocessor (Reset)
If the indication on the display is not normal or if the operation of the unit is not correct, then the microprocessor should be reset by the following procedure.
INPUT SELECTOR 
About the button names in this explanation
<> : Buttons on the main unit
[ | ] : Buttons on the remote control unit |
Button name only :
Buttons on the main unit and remote control unit
¢Simultaneous recording
The signals of the source selected with INPUT SELECTOR are output simultaneously to the
1 Switch off the unit using <POWER>.
2 Keep both <SPEAKER> (A and B) depressed and turn on the unit by pressing <POWER>.
3 Check that the entire display is flashing at
•The microprocessor will be initialized.
•If step 3 does not work, start over from step 1.
•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).
37
ENGLISH