ENGLISH

Getting Started

Cautions on installation

Note:

For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure.

Note

About the remote control unit

In addition to controlling the AVR-687, the attached remote control unit (RC-1048) can also be used to control the following products:

qDENON component products

wComponent products other than DENON:

• Set using the preset memory function ( page 48).

Inserting the batteries

q Remove the remote control

w Set two R6P/AA batteries in

unit’s rear cover.

the battery compartment in

 

the indicated direction.

Getting Started

Operating range of the remote control unit

•Point the remote control unit at the remote sensor when operating it.

•The remote control unit can be used from a distance of approximately 23 feet/7 meters, at a horizontal angle of up to 30° with respect to the sensor.

30° 30°

Wall

ePut the rear cover back on.

Notes on batteries:

•Replace the batteries with new ones if the set does not operate even when the remote control unit is operated nearby the unit. (The attached batteries are only for verifying operation.)

•When inserting the batteries, be sure to do so in the proper direction, following the “<” and “>” marks in the battery compartment.

•To prevent damage or leakage of battery fluid:

•Do not use a new battery together with an old one.

•Do not use two different types of batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in flames.

•Remove the batteries from the remote control unit when you do not plan to use it for an extended period of time.

•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

•Remove the batteries from the remote if it will not be in use for long periods.

3

Approx. 23 feet/7 m

NOTE:

•It may be difficult to operate the remote control unit if the remote sensor is exposed to direct sunlight or strong artificial light.

ENGLISH