This chapter explains how to use EPSON Status Monitor 2.
Making Status Monitor Settings
You can change the settings in EPSON Status Monitor 2 by following the instructions below.
1.Open the Run dialog box from the Start menu or the Control Panel depending on your system. Type the path to the directory where you installed the Status Monitor, followed by Setup. Then click OK.
C:\ESYZ\SETUP
When you have installed the program in directory ESM2 of drive C, type C:\ESM2\SETUP.
Note:
If you installed the program in a directory other than ESM2, type the path to the directory instead of ESM2. If you installed the program in drive C, type C: \ (path) \SETUP.
2.Follow the instructions on the screen.
NT 3.51 & 4.0:
Users can individualize their own settings without affecting the settings of other users.