17
Correcting Distortion in the Projected Image
There are two ways to correct distortion in projected images as below.
• Quick Corner
This allows you to manually correct each of the four corners of the
projected image separately. sp.17
• H/V-Keystone
This allows you to manually correct distortion in the horizontal and
vertical directions independently. H/V-Keystone correction is ideal for
fine-tuning Keystone distortion. You can perform easy corrections by
using the [ ], [ ], [ ], and [ ] buttons on the
projector's control panel. sQuick Start Guide
These two methods cannot be used together. When the "Key stone"
correction method is selected from the Configuration menu, the
correction method you choose is assigned to the control panel
[ ], [ ], [ ], and [ ] buttons. The default setting for
"Keystone" is set to " H/V-Keystone", when [ ], [ ], [ ],
and [ ] buttons are pressed, H/V-Keystone correction is carried
out.
Because "Quick Corner" and "H/V-Keystone" correction can be carried
out while projecting a test pattern, you do not need to make
preparations by connecting a computer or other equipment.
Correcting Distortion with Quick Corner
APress the [Menu] button on the projector, and then
from the configuration menu select Settings -
Keystone. s"Using the Configuration Menu" p.40
BSelect "Quick Corner", and then press the [Enter]
button.
Press the [Enter] button again to display the selection screen from
which you can select one of four corners.
Procedure
Using the remote control Using the control panel