Problem Solving 75

fNothing appears on the external monitor
fProblems when projection starts
fPower does not turn on
Check Remedy
Are images from a port other than the Computer1/2 or BNC
input ports being projected?
The only images that can be displayed on an external monitor are computer images from Computer1/2 or
BNC input ports. sp.101
Check Remedy
Did you press the [t] button? Press the t button to turn the power on.
Are the indicators switched off? The power cable is not connected correctly or power is not being supplied normally.
Disconnect and then reconnect the power cable. sQuick Start Guide
Check that your electrical outlet or power source is functioning correctly.
Do the indicators turn on and off when the power cable is
touched?
There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power
cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service
Guide.
s
Epson Projector Contact List
Is the Control Panel Lock set to "Full Lock"? Press the [t] button on the remote control. If you do not want to use "Control Panel Lock", change the
setting to "Off". s"Settings" - "Control Panel Lock" p.36
Is the correct setting for the remote receiver selected? Check the "Remote Receiver" from the configuration menu. s"Settings" - "Remote Receiver" p.44
Was the power cable plugged back in immediately after
Direct Power Off, or is the breaker turned off?
When the operation to the left is performed when "D irect Power On" is set to "On", the power may not turn
back on. Press the [t] button to turn the power back on.